summaryrefslogtreecommitdiff
path: root/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi
diff options
context:
space:
mode:
authorFaiz Abbas <faiz_abbas@ti.com>2019-06-19 15:54:54 +0530
committerTony Lindgren <tony@atomide.com>2019-06-27 04:38:32 -0700
commitfb59ee37cfe20d10d19568899d1458a58361246c (patch)
tree260d4770adba92b22cef4a909847cb46b6e8746a /arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi
parentf6192c664e217eeb8ee4661c3d9dd22765d6c4a7 (diff)
downloadlinux-sh-fb59ee37cfe20d10d19568899d1458a58361246c.tar.gz
ARM: dts: am57xx: Disable voltage switching for SD card
If UHS speed modes are enabled, a compatible SD card switches down to 1.8V during enumeration. If after this a software reboot/crash takes place and on-chip ROM tries to enumerate the SD card, the difference in IO voltages (host @ 3.3V and card @ 1.8V) may end up damaging the card. The fix for this is to have support for power cycling the card in hardware (with a PORz/soft-reset line causing a power cycle of the card). Because the beaglebone X15 (rev A,B and C), am57xx-idks and am57xx-evms don't have this capability, disable voltage switching for these boards. The major effect of this is that the maximum supported speed mode is now high speed(50 MHz) down from SDR104(200 MHz). commit 88a748419b84 ("ARM: dts: am57xx-idk: Remove support for voltage switching for SD card") did this only for idk boards. Do it for all affected boards. Signed-off-by: Faiz Abbas <faiz_abbas@ti.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
Diffstat (limited to 'arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi')
-rw-r--r--arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi1
1 files changed, 1 insertions, 0 deletions
diff --git a/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi b/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi
index 2341a56ebab9..0cdfd2853ba8 100644
--- a/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi
+++ b/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi
@@ -433,6 +433,7 @@
bus-width = <4>;
cd-gpios = <&gpio6 27 GPIO_ACTIVE_LOW>; /* gpio 219 */
+ no-1-8-v;
};
&mmc2 {