| Age | Commit message (Collapse) | Author | Lines |
|---|
|
to produce sorted results roughly corresponding to RFC 3484/6724,
__lookup_name computes routability and choice of source address via
dummy UDP connect operations (which do not produce any packets). since
at the logical level, the properties fed into the sort key are
computed on ipv6 addresses, the code was written to use the v4mapped
ipv6 form of ipv4 addresses and share a common code path for them all.
however, on kernels where ipv6 support has been completely omitted,
this causes ipv4 to appear equally unroutable as ipv6, thereby putting
unreachable ipv6 addresses before ipv4 addresses in the results.
instead, use only ipv4 sockets to compute routability for ipv4
addresses. some gratuitous conversion back and forth is left so that
the logic is not affected by these changes. it may be possible to
simplify the ipv4 case considerably, thereby reducing code size and
complexity.
|
|
maintainer's note: this change is for conformance with RFC 5952,
4.2.2, which explicitly forbids use of :: to shorten a single 16-bit 0
field when producing the canonical text representation for an IPv6
address. fixes a test failure reported by Philip Homburg, who also
submitted a patch, but this fix is simpler and should produce smaller
code.
|
|
if a final dot was included in the queried host name to anchor it to
the dns root/suppress search domains, and the result was not a CNAME,
the returned canonical name included the final dot. this was not
consistent with other implementations, confused some applications, and
does not seem desirable.
POSIX specifies returning a pointer to, or to a copy of, the input
nodename, when the canonical name is not available, but does not
attempt to specify what constitutes "not available". in the case of
search, we already have an implementation-defined "availability" of a
canonical name as the fully-qualified name resulting from search, so
defining it similarly in the no-search case seems reasonable in
addition to being consistent with other implementations.
as a bonus, fix the case where more than one trailing dot is included,
since otherwise the changes made here would wrongly cause lookups with
two trailing dots to succeed. previously this case resulted in
malformed dns queries and produced EAI_AGAIN after a timeout. now it
fails immediately with EAI_NONAME.
|
|
If AI_NUMERICSERV is specified and a numeric service was not provided,
POSIX mandates getaddrinfo return EAI_NONAME. EAI_SERVICE is only for
services that cannot be used on the specified socket type.
|
|
MAXADDRS was chosen not to need enforcement, but the logic used to
compute it assumes the answers received match the RR types of the
queries. specifically, it assumes that only one replu contains A
record answers. if the replies to both the A and the AAAA query have
their answer sections filled with A records, MAXADDRS can be exceeded
and clobber the stack of the calling function.
this bug was found and reported by Felix Wilhelm.
|
|
some applications use getservbyport to find port numbers that are not
assigned to a service; if getservbyport always succeeds with a numeric
string as the result, they fail to find any available ports.
POSIX doesn't seem to mandate the behavior one way or another. it
specifies an abstract service database, which an implementation could
define to include numeric port strings, but it makes more sense to
align behavior with traditional implementations.
based on patch by A. Wilcox. the original patch only changed
getservbyport[_r]. to maintain a consistent view of the "service
database", I have also modified getservbyname[_r] to exclude numeric
port strings.
|
|
commit d6cb08bcaca4ff1f921375510ca72bccea969c75 moved the code and
introduced an incorrect string offset for the new parsing, probably
due to a copy-and-paste error.
patch by Stefan Sedich.
|
|
due to testing buf[i].family==AF_INET before checking i==cnt, it was
possible to read past the end of the array, or past the valid part. in
practice, without active bounds/indeterminate-value checking by the
compiler, the worst that happened was failure to return early and
optimize out the sorting that's unneeded for v4-only results.
returning on i==cnt-1 rather than i==cnt would be an alternate fix,
but the approach this patch takes is more idiomatic and less
error-prone.
patch by Timo Teräs.
|
|
|
|
this is a clone of the fix to the gethostby*_r functions in
commit fe82bb9b921be34370e6b71a1c6f062c20999ae0. the man pages
document that the getservby*_r functions set this pointer to
NULL if there was an error or if no record was found.
|
|
this case statement was accidently left behind when this function
was refactored in commit e8f39ca4898237cf71657500f0b11534c47a0521.
|
|
posix requires errno to be set to ENXIO if the interface does not exist.
linux returns ENODEV instead so we handle this.
|
|
this code was already under #if 0, but could be confusing if a reader
didn't notice that, and it's almost surely full of bugs and/or
inconsistencies with the current code that uses the gethostbyname2_r
backend.
|
|
loop over an address family / resource record mapping to avoid
repetitive code.
|
|
don't send a query that may be malformed.
|
|
mistakenly ordering strings before addresses in the result buffer
broke the alignment that the preceding code had set up.
|
|
previously if you called getprotobyname("egp") you would get
NULL because \008 is invalid octal and so the protocol id was
interpreted as 0 and name as "8egp".
|
|
The variable nss is set to zero in following line.
|
|
|
|
name_from_hosts failed to account for the possibility of an address
family error from name_from_numeric, wrongly counting such a return as
success and using the uninitialized address data as part of the
results passed up to the caller.
non-matching address family entries cannot simply be ignored or
results would be inconsistent with respect to whether AF_UNSPEC or a
specific address family is queried. instead, record that a
non-matching entry was seen, and fail the lookup with EAI_NONAME of no
matching-family entries are found.
|
|
|
|
|
|
search is only performed if the search or domain keyword is used in
resolv.conf and the queried name has fewer than ndots dots. there is
no default domain and names with >=ndots dots are never subjected to
search; failure in the root scope is final.
the (non-POSIX) res_search API presently does not honor search. this
may be added at some point in the future if needed.
resolv.conf is now parsed twice, at two different layers of the code
involved. this will be fixed in a subsequent patch.
|
|
rcode of 3 (NxDomain) was treated as a hard EAI_NONAME failure, but it
should instead return 0 (no results) so the caller can continue
searching. this will be important for adding search domain support.
the top-level caller will automatically return EAI_NONAME if there are
zero results at the end.
also, the case where rcode is 0 (success) but there are no results was
not handled. this happens when the domain exists but there are no A or
AAAA records for it. in this case a hard EAI_NONAME should be imposed
to inhibit further search, since the name was defined and just does
not have any address associated with it. previously a misleading hard
failure of EAI_FAIL was reported.
|
|
|
|
this change is made in preparation for adding search domains, for
which higher-level code will need to parse resolv.conf. simply parsing
it twice for each lookup would be one reasonable option, but the
existing parser code was buggy anyway, which suggested to me that it's
a bad idea to have two variants of this code in two different places.
the old code in res_msend potentially misinterpreted overly long lines
in resolv.conf, and stopped parsing after it found 3 nameservers, even
if there were relevant options left to be parsed later in the file.
|
|
The return value of if_nametoindex is unsigned; it should return 0
on error.
|
|
|
|
With point-to-point interfaces, the IFA_ADDRESS netlink attribute
contains the peer address while an extra attribute IFA_LOCAL carries
the actual local interface address.
Both the glibc and uclibc implementations of getifaddrs() handle this
case by moving the ifa_addr contents to the broadcast/remote address
union and overwriting ifa_addr upon receipt of an IFA_LOCAL attribute.
This patch adds the same special treatment logic of IFA_LOCAL to
musl's implementation of getifaddrs() in order to align its behaviour
with that of uclibc and glibc.
Signed-off-by: Jo-Philipp Wich <jow@openwrt.org>
|
|
getnameinfo() compares the size of the given struct sockaddr with
sizeof(struct sockaddr_in) and sizeof(struct sockaddr_in6) depending on
the net family. When you add a sockaddr of size sizeof(struct
sockaddr_storage) this function will fail because the size of the
sockaddr is too big. Change the check that it only fails if the size is
too small, but make it work when it is too big for example when someone
calls this function with a struct sockaddr_storage and its size.
This fixes a problem with IoTivity 1.0.0 and musl.
glibc and bionic are only failing if it is smaller, net/freebsd
implemented the != check.
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
|
|
previously, transient failures like fd exhaustion or other
resource-related errors were treated the same as non-existence of
these files, leading to fallbacks or false-negative results. in
particular:
- failure to open hosts resulted in fallback to dns, possibly yielding
EAI_NONAME for a hostname that should be defined locally, or an
unwanted result from dns that the hosts file was intended to
replace.
- failure to open services resulted in EAI_SERVICE.
- failure to open resolv.conf resulted in querying localhost rather
than the configured nameservers.
now, only permanent errors trigger the fallback behaviors above; all
other errors are reportable to the caller as EAI_SYSTEM.
|
|
previously, __lookup_ipliteral only checked its argument against the
requested address family, so IPv4 literals passed through to
__lookup_name if the caller asked for only IPv6 results, and likewise
for IPv6 literals when the caller asked for only IPv4. this resulted
in spurious DNS lookups that reportedly even succeeded with some
nameservers.
now, __lookup_ipliteral attempts to parse its argument as both IPv4
and IPv6, and returns an error (to stop further search) rather than 0
(no results yet) if the form of the argument mismatches the requested
address family.
based on patch by Julien Ramseier.
|
|
this case is specified as a mandatory ("shall fail") error.
based on patch by Julien Ramseier.
|
|
|
|
due to a reversed pointer difference computation, ns_skiprr always
returned a negative value, which functions using it would interpret as
an error.
patch by Yu Lu.
|
|
one stop condition for parsing abbreviated ipv6 addressed was missed,
allowing the internal ip[] buffer to overflow. this patch adds the
missing stop condition and masks the array index so that, in case
there are any remaining stop conditions missing, overflowing the
buffer is not possible.
|
|
|
|
all socket types are accepted at this point, but that may be changed
at a later time if the behavior is not meaningful for other types. as
before, omitting type (a value of 0) gives both UDP and TCP results,
and SOCK_DGRAM or SOCK_STREAM restricts to UDP or TCP, respectively.
for other socket types, the service name argument is required to be a
null pointer, and the protocol number provided by the caller is used.
|
|
based on patch by Timo Teräs, with some corrections to bounds checking
code and other minor changes.
while they are borderline scope creep, the functions added are fairly
small and are roughly the minimum code needed to use the results of
the res_query API without re-implementing error-prone DNS packet
parsing, and they are used in practice by some kerberos related
software and possibly other things. at this time there is no intent to
implement further nameser.h API functions.
|
|
if the loop stopped due to reaching the end of the string, the
subsequent increment could possibly move the position one past the end
of the buffer. no further writes happen, the reads cannot fault anyway
unless the stack completely lacks any zero bytes, and reading junk
should not yield an incorrect result from the function either.
nonetheless the code was wrong and needs to be fixed.
|
|
the condition was probably intended to be !*p rather than !p, but
neither is needed here. the subsequent code naturally handles the case
where it's already at end of string.
|
|
the outer getnameinfo function already has a properly-sized temporary
buffer for storing the reverse dns (ptr) result. there is no reason
for the callback to use a secondary buffer and copy it on success, and
doing so potentially expanded the impact of the dn_expand bug that was
fixed in commit 49d2c8c6bcf8c926e52c7f510033b6adc31355f5.
this change reduces the code size by a small amount, and also reduces
the run-time stack space requirements by about 256 bytes.
|
|
Empty name was rejected in dn_expand since commit
56b57f37a46dab432247bf29d96fcb11fbd02a6d
which is a regression as reported by Natanael Copa.
Furthermore if an offset pointer in a compressed name
pointed to a terminating 0 byte (instead of a label)
the returned name was not null terminated.
|
|
the previous implementations had several deficiencies, the most severe
of which was the inability to report unconfigured interfaces or
interfaces without ipv4 addresses. among the options discussed for
fixing this, using netlink turned out to be the one with the least
cost and most additional advantages. other improvements include:
if_nameindex now avoids duplicates in the list it produces, but still
includes legacy-style interface aliases if any are in use.
getifaddrs now reports hardware addresses and includes the scope_id
for link-local ipv6 addresses in the resulting address.
|
|
for LC_MESSAGES, translation of strerror and similar literal message
functions is supported. for messages in other places (particularly the
dynamic linker) that use format strings, translation is not yet
supported. in order to make it possible and safe, such messages will
need to be refactored to separate the textual content from the format.
for LC_TIME, the day and month names and strftime-style format strings
provided by nl_langinfo are supported for translation. however there
may be limitations, as some of the original C-locale nl_langinfo
strings are non-unique and thus perhaps non-suitable as keys.
overall, the locale support activated by this commit should not be
seen as complete and polished but as a basis for beginning to test
locale functionality and implement locales.
|
|
iptables and quagga need them to work.
|
|
|
|
according to the documentation in the man pages, the GNU extension
functions gethostbyaddr_r, gethostbyname_r and gethostbyname2_r are
guaranteed to set the result pointer to NULL in case of error or no
result.
|
|
this case is not even documented, but the kernel returns 0 here and it
makes sense to be consistent.
|
|
these are not pure syscall wrappers because they have to work around
kernel API bugs on 64-bit archs. the workarounds could probably be
made somewhat more efficient, but at the cost of more complexity. this
may be revisited later.
|
